Conclusion

Conclusion and general remarks

An attempt has been made in this experimental apparatus to study pressure losses in various components in a piping system consisting of straight pipes, sudden expansion and contraction, bends and valves. The general trends and magnitudes obtained during experiments will be the indication of the pressure loss from various components in the pipe system. However, in practical situations, such combinations are not adopted over a short span length. The normally accepted design criterion for pressure tappings is 30 to 50 pipe diameters away from obstruction. Also, sufficient pipe length has been left between each component in the circuit to eliminate any adverse influence of the neighboring components. Thus, any discrepancies between experimental and theoretical results may be attributed due to three main factors;

•  Relatively small physical scale of the pipe work

•  Relatively small pressure differences

•  Low Reynolds numbers

Minute Meeting 3

“FLUID MECHANICS IS FUN” (PROJECT 2) MEETING NO: 3

DATE    : 12^th  MAY 2018

TIME     :  8.30PM – 10.30PM

VENUE : UTHM Pagoh Residential College Cafe

PRESENT

1.     WONG SIEW MIEW

2.     NUR ELLIYANA AIMAN BINTI ABDUL WAHID

3.     ALIA FARHANA BINTI MALIK

4.     NORUL AHSANAH AULIA BINTI MOHAMAD MAHANI

BIL	AGENDA	ACTION
1.	Welcome the group members and understand the objective of meeting, that is to check up on the progress of the project.	Group Leader and Group Members
2.	Each group member show their progress and completion of their project that should be presented in the electronic medium (blogspot).	Group Members
3.	Group Members exchange picture to put in the introduction of the group members	Group Members
4.	Last checking on the completion for overall project work for the presentation using electronic medium	Group Members

Prepared by: Nur Elliyana Aiman (Group Secretary)
Checked by : Wong Siew Miew (Group Leader)

Minute Meeting 2

“FLUID MECHANICS IS FUN” (PROJECT 2) MEETING NO: 2

DATE    : 3^RD  MAY 2018

TIME     :  8.30PM – 10.30PM

VENUE : UTHM Pagoh Residential College Cafe

PRESENT

1.     WONG SIEW MIEW

2.     NUR ELLIYANA AIMAN BINTI ABDUL WAHID

3.     ALIA FARHANA BINTI MALIK

4.     NORUL AHSANAH AULIA BINTI MOHAMAD MAHANI

BIL	AGENDA	ACTION
1.	Welcome the group members and understand the objective of meeting, that is to check up on the progress of the project.	Group Leader and Group Members
2.	Each group member state and exchange  their findings and research then discuss about the pipe system subtopics that is important and what should be presented in the electronic medium (blogspot).	Group Members
3.	Group members that is in charge to create a blogspot and email shares the details about the blog. Email – fluidmechanic7@gmail.com Blog – fluidmechanic7@blogspot.com	Group Members
4.	Group Members exchange their Matrics No. and Full name for the introduction of the group members in the blog.	Alia Farhana

Prepared by : Nur Elliyana Aiman (Group Secretary)

Checked by : Wong Siew Miew (Group Leader)